Services / AMC & Maintenance
Cold Room AMC and Maintenance Service in India — 24-Hour Emergency Support
A cold room is a 10–15 year asset and lives or dies by maintenance. HyperCold's AMC keeps refrigeration tuned, controls calibrated, panels clean and electrical safe — across three service tiers, with 24-hour emergency response.
We service cold rooms HyperCold built and take over AMC for cold rooms built by others, provided we can do a one-time engineering audit first.
- Standard, Pro and 24×7 Critical AMC tiers
- Quarterly preventive maintenance visits
- Refrigeration tune-up, controls calibration
- Annual leak test, oil check, performance log
- 24-hour emergency telephone & on-site response
- AMC takeover for non-HyperCold cold rooms
Typical applications
Technical Specifications & Construction
Every cold room amc we build follows the same engineering discipline — sized to your load, not picked off a brochure. Specifications below reflect typical HyperCold builds.
- AMC tiers
- Standard / Pro / 24×7 Critical
- Preventive visit frequency
- Quarterly (standard), Monthly (critical)
- Refrigerant top-up
- Included up to defined limit per tier
- Controls calibration
- Temperature, RH, pressure sensors yearly
- Emergency response SLA
- Telephone < 1 hr, on-site < 24 hr (tier-dependent)
- Spare parts kit
- Pre-stocked at multi-site clients on Pro+
How HyperCold Designs This Cold Room
These are the design factors we lock down before quoting. Skip any of these and the project either runs hot, drinks electricity, or under-delivers on shelf life.
Product-specific temperature & humidity
We design from the commodity's psychrometric envelope, not a generic chiller spec. Different storage life targets get different design points.
Humidity & moisture control
Coil sizing, defrost strategy and air-throw decide whether your product dries out, sweats, or holds quality.
Air change rate & throw pattern
Velocity through the stack governs uniform pull-down. We engineer 25–60 ACH per room volume, not a default.
Refrigeration sizing on actual load
Heat load is calculated from product, infiltration, lighting, defrost, motor and personnel — never a TR/MT thumb rule.
Panel selection by ambient
100 mm in moderate zones, 150 mm in Rajasthan / interior MH. Panel density never below 40 kg/m³.
Serviceable layout & AMC access
Compressor decks, drain lines and electrical panels laid out for one-hand servicing — saves cost over 10 years.
What Drives the Project Cost
We don't quote square-foot rates — every build is BOQ-priced. The factors below decide where your project lands within a realistic range.
- 01Cold room size and temperature band
- 02Refrigeration TR and compressor count
- 03Number of doors and door-cycle intensity
- 04Site location and distance from nearest HyperCold hub
- 05AMC tier (Standard / Pro / 24×7 Critical)
- 06Spare-parts inclusion model
- 07Pharma / NHB / FSSAI documentation needs
- 08Multi-site or single-site contract
Why Operators Choose HyperCold
Lower lifetime cost
AMC-tuned rooms run 10–25% less kWh than neglected rooms — AMC pays for itself within 18–30 months.
Asset life protection
Compressor and panel life extended significantly with planned maintenance vs reactive repair.
Compliance-ready logs
Temperature data logs, calibration certificates and visit reports for FSSAI / pharma audit trails.
Predictable downtime
Planned PM windows replace surprise breakdowns — critical for HORECA, pharma and frozen food.
Frequently Asked Questions
Subsidies & finance that may apply
Eligibility depends on project type, applicant category, state and current government notification. Below is indicative — verify with the official scheme portal before applying.
MIDH (State Horticulture Mission)
Credit-linked back-ended capital assistance for horticulture cold storage and pack houses.
Read scheme detailsNHB Cold Storage Subsidy
National Horticulture Board capital subsidy for cold storage and CA storage projects.
Read scheme detailsMoFPI Integrated Cold Chain (PMKSY)
Grant-in-aid for integrated pre-cooling, IQF, blast freezing, CA and reefer logistics.
Read scheme detailsAgriculture Infrastructure Fund (AIF)
Interest subvention and credit guarantee on bank term loans for post-harvest infrastructure.
Read scheme detailsPMFME — Micro Food Processing
Credit-linked subsidy for micro food processing units including small cold rooms.
Read scheme detailsState Subsidy Schemes
State Horticulture, Food Processing, SC/ST and SHG components vary by state action plan.
Read scheme detailsMSME & Bank Finance (CGTMSE, SIDBI, NABARD)
Term loan and working capital options via scheduled banks, SIDBI, NABARD and cooperatives.
Read scheme detailsReady to scope your cold room amc?
Share your product, room size, and target temperature. We'll send a BOQ-priced quote with PUF, refrigeration, installation, and AMC — pan-India delivery from Sirsaganj, Firozabad.